923316010_09_008
Page
3
from
4
Suspended ceiling
Α-3018
mounting springs
PLACING
Α-
CRV PARTS
To install the curve crystal
Α-
CRV
you must first install the
included plastic extension to mount it on the TEST button
.
1
2
3
Mounting methods
All
“
Easy Light
”
can be mounted either surface or recess
mounted in walls or suspended ceilings. For recess
mounted installations, special accessories are required
which can be found in the catalog and must be ordered
separately.
Suspended ceiling installation
.
On the bottom of the base plastic of the Easy light
luminaire there are two
H
shaped cut outs
.
These are
used to install the A-3018 mounting springs.
1. With a sharp tool remove the appropriate plastic
pieces to fit the mounting springs. First place the edges
of the mounting spring to the respective holes and install
the one end of the coil to the support axis.
2.
Install the other end of the coil to the other support
axis.
3.
Bend the springs and place the luminaire to the
respective suspended ceiling’s hole
.
The luminaire’s placement to the suspended ceiling
must be done after the connection with power supply
cables.
Recess mounting in a wall
The special mounting base (A-3016) can be built in the
wall and on it can be mounted the luminaire with the
Α-
3016
included screws
,
following the installation
instructions of the luminaire
.
The mounting base
contains pre-etched holes for cable entry that are
aligned with the cable entry holes of the luminaire.
Bottom view of a wall
Α-3016
recess
mounting base
Mounting Easy Light luminaire
in a suspended ceiling
Recess mounting for an ‘’Easy Light
”
luminaire in a wall
.
Required
opening in
a suspended
ceiling
340
124
MARKING PANEL SP-114
A marking panel SP-114 can be installed on the
luminaire in 3 different locations. This marking
panel is installed perpendicular to the diffusor of
the luminaire, as shown in the pictures below.
The panel is pre-printed and has a plastic
accessory on each side that is used to fasten the
panel to the luminaires
.
There are 2 arrow stickers that can be placed in
each side of the marking panel to point to the
desired direction.
Placing the SP-114 marking panel
Place the plastic mounting accessories of the
marking panel as shown in pictures
.
ΝΟΤΕ!!
This marking panel (SP type) can not
be installed on CRV luminaires.