Page
3
from
5
Mounting the luminaire in suspended ceiling.
Set up the luminaire to the suspended ceiling as it is shown bellow
(Required opening 110mm)
:
Step 1
Bend the springs, to get into the hole of the suspended ceiling, as you can see to the next figure.
Step 2
Push up the luminaire, as shown in figure 2.
Step 3
Continue to push upwards until the lamp locks.
If you want to pull off the device,
put a flat blade
screwdriver, between the device and the ceiling.
Figure 2
Figure 3
Figure 1
Surface mounting
.
Install the luminaire according to the following steps
:
Step 1
.
Follow the step 1
of the installation instructions
.
Step 2.
Unfasten the retaining screw (Figure 4) and detach the part for suspended ceiling installation.
Step 3
.
(Figure 5)
Drill 2 holes on the base
using a 4mm drill bit in order to permit the retaining screws to
pass. Mark these two drilled points on the required mounting location, drill the holes and install the
supplied plastic plugs.
Step 4.
Install the decorative rim (package included).
Step 5. ATTENTION!!
In order to sustain the IP 65 rating, fit the washer on to the screw and then fit the
insulation ring that is included in the package ( igure
6
). Next, use these 2 fasteners to install the unit to
F
the require location.
Finally install perimetrically the waterproofing gasket
(package included).
Step 6.
Follow the steps 2,3 and 4 of the installation instructions.
Ø110mm
Figure
6
Figure 4
Figure
5
Drill here
Indications
Retaining fastener
923298002_09_003
