Page
4 from
5
Lamp fault
indication LED
GR-29
0
/WP, GR-292/WP
GR-291/WP, GR-293/WP
ATTENTION!!!
During installation follow this light direction.
Corridor
lighting
Open
area
lighting
Important notice for the installed luminaires in one area !!!
The installer must connect the battery’s connector first and then should power the luminaire.
The time between batteries connection must be, at least 1.5 minute.
With this variation, it is ensured that the non synchronized Automatic Autonomous Test for
two or more luminaires installed in one area, is not conducted in the same day.
Battery replacement
.
It can be done only by a competent person and after the mains interruption.
1. Remove the luminaire from the suspended ceiling (figure 3).
2.
Follow the step
1
of the installation
instructions
.
3
. Disconnect the connector and remove the old battery.
4
. Connect the new battery with the same type (step
2
of the installation
instructions
) and place it in
the position of the old one.
5. Replace the removed parts (step 1 and 4) and power the device.
FAULT
LAMP
CHARGE
BATT.
FAULT
LAMP
CHARGE
BATT.
9
6
6
5
125
FAULT
LAMP
CHARGE
BATT.
FAULT
LAMP
CHARGE
BATT.
Battery
fault
indication
LED
Battery
charge
indication
LED
Figure 4
LED MODULE CHARACTERISTICS
Manufacturer
Model Number
Voltage Range
Connections
Nominal Power
Temperature (tc)
Olympia Electronics S.A
60 °C max. across the board
45 °C max. across the board
Non reversible connection between main pcb and led module
3-3.2VDC
2.2W
1.1W
1110143
2704143
GR-29
0
/WP
GR-291/WP
GR-292/WP
GR-293/WP
Status of LEDs
LEDs
Description of indication
CHARGE : Battery charging, : battery charged, : disconnected or unfunctional battery
LAMP FAULT : Operation check, : lamp fault, : normal operation
BATT. FAULT : Autonomy test, : battery fault, : normal operation
Note : Blinking, : constantly on, : off
CAUTION
:
Do not view directly with bare eyes.
923293005_09_004
