Step 1
Push up the luminaire, as shown in figure 2.
Bend the springs, to get into the hole of the suspended ceiling, as you can see to the next figure.
Set up the lamp to the suspended ceiling as it is shown bellow
(Required opening 110mm)
:
Mounting the lamp in suspended ceiling
Step 2
Step 3
Continue to push upwards until the lamp locks.
If you want to pull off the device,
put a flat blade
screwdriver, between the device and the ceiling.
Figure 2
Figure 3
Figure 1
Ø110mm
Page
4 from
6
Figure 4
Figure 5
Drill here
Indications
Retaining fastener
Step 2.
Unfasten the retaining screw (Figure 4) and detach the part for suspended ceiling installation.
Step 5.
Follow the step 3 of the installation instructions.
SURFACE MOUNTING
Step 1.
Follow the step 1 of the installation instructions.
Install the luminaire according to the following steps
:
Step 3
.
Drill 2 holes on the base using a 4mm drill bit in order to permit the retaining screws to pass. Mark
these two drilled points on the required mounting location, drill the holes and install the supplied
plastic plugs.
ATTENTION
!!
Especially for the
GR-290/M
and
GR-292/M
luminaire installation
on the ceiling you must align the base with the indications on the luminaire’s base (Figure 5)
.
Step 4.
Install the decorative rim (package included).
Next, use the 2 fasteners to install the unit to the
require location.
923293003_09_006
