Page
2 from
6
ΑΤΤΕΝΤΙΟΝ
!!!
1.
Operations for installation, maintainance or
testing must be done by authorized personnel
only
.
2.
The luminaire must be connected to the
mains power supply through a fuse dependent
on the total amount of the line’s power load
.
3
.
It is suggested to check every month the
indication LED for battery charging, and by
pushing the TEST button to check the
emergency circuit. The led strip should light as
long as the TEST button is pressed.
It is suggested to check every 6 months the
m i n i m u m a u t o n o n o u s d u r a t i o n b y
disconnecting the mains power supply
.
Count
the time that the led strip lights and in case of
less time than the minimum autonomous
duration the battery must be replaced. If the
measured time is considerably less than the
minimum autonomous duration
In case of battery or led strip
If the
luminaire doesn’t work as described above
contact the installer.
contact the
installer.
4.
replacement, these must be replaced by parts
of the same type,
by the manufacturer or
by a
competent person.
t i
in battery recycling
points.
Do not incinerate.
The light source contained in this
luminaire shall only be replaced by the
manufacturer, or his agent, or a similar
qualified person.
NOTE! The light source is non-user replaceable.
5.
In case of inactive use for a period greater
than 2 months, disconnect the battery by pulling
out the battery’s connector.
6
.
I s not allowed to discard batteries in to
common trash bins, they must be
discarded only
Olympia Electronics S.A
.
40 °C max. across the board
Plug in connection (take care of orientation between the main pcb and led module)
2,
8
-
3
,
3
V DC
3
W
2602185
/15
LED
CLD-30/NST
92250300
1
_09_001
Manufacturer
Model Number
Voltage Range
Connections
Nominal Power
Temperature (tc)
LED MODULE CHARACTERISTICS
NOTE:
LED=
Light Emitting Diode
LABELING EXPLANATION:
X:
Self contained
1
:
Maintained
(*)
A:
Including test device
G:
Internally illuminated
180:
3 hours duration
(*)
Maintained operation: The luminaire lights its
illumination source, when it is powered by the mains
power supply or not
.
Non
Maintained operation: The luminaire lights its
illumination source,
only in power supply’s failure.
