923119004_09_004
1
Lock - unlock hook
3
Installation instructions
Οn:
faulty LED strip.
Off:
Good LED strip.
Fault
Οff:
Battery OK.
Blink
(With
AC Charge LED
ON): Autonomy or
low battery problem
(the battery must be replaced).
Blink
(With
AC Charge LED
Off):
No charging current or disconnected battery.
ΑΤΤΕΝΤΙΟΝ!!!
1. Operations for installation, maintainance or
testing must be done by authorized personel
only.
2. The device must be connected to the mains
power supply thru a fuse dependent by the total
amount of the line’s power load.
3.
4. In case of inactive use for a period greater
than 2 months, disconnect the battery by pulling
out the battery’s connector.
5.
I
s not allowed to discard batteries in to
c o m m o n t r a s h b i n s , t h e y m u s t b e
discarded only
In case of battery or lamp replacement, these
must be replaced by parts of the same type, by
the manufacturer or by a competent person.
t i
in battery recycling
points. Do not incinerate.
NOTE:
LED= Light Emitting Diode
LABELING EXPLANATION:
X: Self contained
1: Maintained
A: Including test device
*90: 90min duration
1 Detach the plastic base (located in the bottom of the luminaire)
by pulling the unlock hook and pass the cables from area or
and through the cable entry hole. Secure it with a suitable
bracket to ensure immobilization of the cable at a distance of
no more than 5cm from the luminaire’s cable entry. Mount the
plastic base with the included mounting accessories.
2 Connect the cables to the terminal blocks as showed in figure.
AC1 for L, AC2 for Ν and L1 for the maintained operation.
The L1 wire can be connected to an external switch to control
the maintained or non maintained operation of the luminaire.
For permanent maintained operation use two wires to power
the luminaire, AC1 for L, AC2 for Ν and link the L and L1.
3 Attach the luminaire by sliding it on the plastic base until the
plastic hook locks, and power the luminaire.
AC1
AC1
AC2
AC2
External
switch
Link
Controled operation of the luminaire
Permanent maintained operation
N
L
L1
N
L
L1
Page 2 from 2
A
B
Plastic base
2
N
L
A
B
AC1
AC2
L
1
Cable entry hole
Cable
support
Battery replacement
It can be done only by a competent person and after the mains interruption.
1. Detach the lamp from its base ( step 1 of the installation procedure ) .
2. Use a flat blade screwdriver to remove the diffusor.
3. Remove the reflector.
4. Disconnect the connector and remove the old battery.
5. Connect the new battery with the same type and place it in
the position of the old one.
6. Replace the removed parts (steps 1,2 and 3).
2