LED
OFF ON
LED
OFF ON
LED’s are enabled
LED’s are disabled
High sensitivity
. 2
pulses for stable
environment.
Note: For long detection range set the switch
in OFF position.
PIR
PIR
OFF ON
OFF ON
Low sensitivity
. 3
pulses for
harsh environment
.
MW low range control according to the
room size with detection range for
m
5 - 9 .
Immunity to an animal up to 25 kg
``OR`` operation. The alarm signal
(relay activation) occurred when one
of the sensors signal (PIR & MW) is
present.
MW
PET
Α/Ο
MW
PET
Α/Ο
OFF ON
OFF ON
OFF ON
OFF ON
OFF ON
OFF ON
PIR adjustment
Use the Potentiometer marked
"PIR"
to adjust the
detection sensitivity between 15% and 100%,
according to walk test in the protected area.
(Factory setting is 57%)
Rotate the potentiometer clockwise to increase
range, counter-clockwise to decrease range.
MW high range control according to the
room size with detection range for
m
10 - 18 .
Immunity to an animal up to 15 kg
``AND`` operation. The alarm signal
occurred only when both sensor signals
(PIR and MW) are present at the same
time.
Description of the detector adjustments
Connection terminals
indication
LED’s
Sensor
Μ
W sensitivity
control
LED
PIR
MW
MW
PET
A/O
-12V+ TAMP EOL RELAY
PIR ALARM DOP
PIR
PIR range
control
Microswitches
Microswitche’s operation
Selecting mounting location
The detector must be installed in areas that can cover the
larger area as possible. Avoid locations that can cause false
alarms. These locations are:
- Facing direct sunlight.
- Facing areas that may change temperature rapidly.
- Areas where there are air ducts or substantial airflows.
- Avoid screen, curtain that may block detection area.
- Do not install outdoors.
The detector can either be wall or corner mounted. If ceiling or
special wall mounting is required, use the optional bracket base
with the included parts (BASE-401).
Refer to bracket description. (See fig. 4)
Down and side view
Figure
3
TAMPER
switch
Page 2 from 3
SENSITIVITY CONTROL
Position the potentiometer
"MW"
at min-scale firstly,
then, along with walk testing, turn to mid-scale or max-
scale gradually until you get detection at the longest
distance for the required detection range.
Rotate the potentiometer clockwise to increase range,
counter-clockwise to decrease range.
921409000_09_003
