Olymp GOsafe 120FP Series, Руководство по эксплуатации

Страница: 11 / 38

10
Setting the fingerprint (only for 120FP & 210FP)
• Open the door and press the reset button once.
• You will hear 2 short buzzer sounds and see a yellow light flashing.
• Place your finger on the fingerprint sensor and then remove it.
• You will hear 2 buzzer tones and see a yellow light flashing.
• Repeat the previous step two more times.
• Finally, you will hear a long beep, which means that the new fingerprint has been successfully registered.
ATTENTION: A maximum of 30 fingerprints are supported!
Please use the same finger when registering fingerprints!
To improve the rate of correct finger identification, you can follow the advice below:
We recommend that each user register 2-3 fingerprints.
We recommend women and children to register with thumb and middle finger.
Try to press with even force.
In very dry weather, we recommend breathing on the fingers until they are a little wet.
Switch between single and double entry mode (only for 120FP & 210FP)
• Open the safe.
• Press "1" on the keypad and the reset button at the same time.
• You will hear a long buzzer tone.
• This means that the switch between single and double entry mode was successful.
Alarm - Wrong code
• If 3 incorrect code entries or 5 incorrect fingerprint entries are made, a warning tone sounds for 20 seconds.
ATTENTION: You can stop the beeps by entering the correct code or fingerprint within 20 seconds.
Alarm - Shake alarm
• Press "*" while the unit is in sleep mode.
• then the vibration alarm system is activated.
• The safe will sound an alarm for 20 seconds if it is moved or shaken.
• You can stop the alarm by entering a password or fingerprint (only for 120FP & 210FP).
Restoring the factory settings
• Open the safe.
• Press the reset button and hold it down for 8 seconds.
• You will hear a long beep.
• The safe is reset to the factory settings.
In the factory settings, the user code is "1234" and the master code is "123456" and any fingerprint (only for 120FP
& 210FP) will allow the safe to be opened.
ATTENTION: In the factory settings, the safe is in single-entry mode.
Turning the sound off/on
• Press "0" twice and "*" once to activate mute mode.
• Press "6" twice and "*" once to end the mute mode.
ATTENTION: The safe is in mute mode when the battery is low. Alarm beep is still activated during mute mode.