6
CLEAN Channel CH2
The clean channel is an old school type of channel with separate bass and treble
controls.
TREBLE, BASS
High and low frequency tone controls.
VOLUME
Pre-amp volume control.
CH1/CH2
Selects either the LEAD Channel (CH1) or the CLEAN Channel (CH2). When
connecting a foot switch set the CHANNEL switch in position CH1 to get the foot
switch to work.
LEAD Channel CH1
The LEAD channel delivers many different kinds of harmonically distorted tube
sounds depending on gain settings.
VOLUME
This knob adjusts the LEAD channel’s volume. First set the GAIN to the 9 o’clock
position. If you wish to get creamy lead tones, turn the knob well up to dial in
smooth power amp saturation. If you’re looking for an edgier metal sound, try
backing off the VOLUME knob and turning up the GAIN knob. Usually smooth power
amp saturation is less desirable for this type of metal tone.
TREBLE, MID, BASS
High, middle and low frequency controls.
LOW/HIGH
In low position the input sensitivity is lower than in high mode. Also a bit more
bottom end is added in Low mode.
GAIN
This knob adjusts the amount of tube distortion. To explore the fantastic range of
sounds that this channel puts at your fingertips, we recommend that you first set the
GAIN knob to around 10 o’clock position, and then experiment with the guitar’s
volume knob and pickup selector.
INPUT
Connect your guitar to this input. You must use a shielded cord of good quality.
2.2 Rear panel
Serial FX Loop
The Little Hill is equipped with a series FX loop. The effects loop is connected
