Control panel
F.
POWER SWITCH – Turns the amplifier on-off as indicated by the jewel unit.
G.
STANDBY – When the amplifier is on, Standby will mute all audio output from the amplifier.
Use Standby during short breaks to avoid the tube warm up delay.
Select Standby for the first 60 seconds when switching the amplifier ON to extend tube life.
H.
JEWEL UNIT – Indicating power on
I.
REVERB – Sets the amount of reverb
J.
TONE 2 – Adjusts the tone characteristics of the amplifier for channel 2
K.
VOLUME 2– Adjusts the volume of channel 2. Channel 2 is the brightest channel.
L.
TONE 1 – Adjusts the tone characteristics of the amplifier for channel 1
M.
VOLUME 1 – Adjusts the volume of channel 1. Channel 1 is a darker channel.
N.
CHANNEL SWITCH – Selects input channel. Select channel 2 when using the footswitch.
O.
INSTRUMENT INPUT – Input jack for your guitar.
P.
DEEP CUT – Decreases the low frequencies.
Specifications
Type:
CUR362
2x12”
Pre amp tubes:
3 x ECC83/12AX7, 1 x 12AT7
Power amp tubes:
4 x EL84
Rectifier tube:
1 x GZ34
Input impedance:
1M
Ω
Output power:
36/18 Watt into 8
Ω
at 5% THD , 1kHz
Output impedance:
4 or 8 ohm
Power requirement:
150 Watt
Speaker:
CUR362 – Celestion Creamback
Dimensions (W*D*H):
CUR362 230(l)x715(b)x540(h) mm
Weight:
CUR 362 -29kg
Operating temperature: 0-35
°
C
Product specifications are subject to change without notice
EUROPE ONLY
- NOTE: This equipment has been tested and found to comply with the
requirements of the EMC directive (Environments E1, E2 and E3 EN 55103-1/2) and the Low Voltage
Directive in the E.U
F
G
I
J
M
N
O
H
K
L
P
