Control panel
E.
POWER SWITCH – Turns the amplifier on-off as indicated by the jewel unit.
F.
STANDBY – When the amplifier is on, Standby will mute all audio output from the amplifier.
Use Standby during short breaks to avoid the tube warm up delay.
Select Standby for the first 60 seconds when switching the amplifier ON to extend tube life.
G.
JEWEL UNIT – Indicating power on
H.
DEEP CUT – Decreases the low frequency response.
I.
REVERB – Sets the amount of reverb mixed into the dry sound.
J.
DWELL – Sets the input signal to the reverb tank. Higher settings will increase the decay time.
Note that to high setting can make the reverb signal to be distorted.
K.
TONE – Adjusts the tone characteristics of the amplifier.
L.
VOLUME 2– Adjusts the volume of channel 2. Channel 2 is a bit brighter then channel 1.
M.
VOLUME 1 – Adjusts the volume of channel 1.
N.
INSTRUMENT INPUT – Input jack for your guitar.
Specifications
Type:
CL40
Pre amp tubes:
3 x ECC83/12AX7, 1 x 12AT7
Power amp tubes:
2 x 6L6GC or 2 x EL34
Rectifier tube:
1 x GZ34 can be used instead of the standard diode adapter.
You must adjust the BIAS when changing between diode and rectifier tube,
or vice versa.
Input impedance:
1MΩ
Output power:
40/35W with 6L6GC/EL34
Output impedance:
2, 4 or 8 ohm
Power requirement:
150 Watt
Speaker:
Celestion Creamback 65W
Dimensions (W*D*H):
267(l)x510(w)x435(h)
Weight:
22kg
Operating temperature: 0-35
°
C
Product specifications are subject to change without notice
EUROPE ONLY
- NOTE: This equipment has been tested and found to comply with the
requirements of the EMC directive (Environments E1, E2 and E3 EN 55103-1/2) and the Low Voltage
Directive in the E.U
E F
I
J
M N
G
K
L
H
