11
vI - PLACING ThE bOILER
NOTE:
Refer to
“Locating The Boiler”
in Sec
-
tion V of this manual for required clearances for
servicing and maintenance.
The boiler must be located on a surface that
can support the weight of the installed boiler.
WARNING
!
The boiler should be placed to provide the most direct
connections to the combustion air, vent and system piping
as possible.
Place crated boiler as close to selected location as possi-
ble and uncrate boiler. The uncrated boiler may be moved
v - bEfORE INsTALLING ThE bOILER
Place in operation the appliance being inspected. Fol-
4.
low the lighting instructions. Adjust thermostat so appli-
ances will operate continuously.
After it has been determined that each appliance re-
5.
maining connected to the common venting system
properly vents when tested as outlined above, return
doors, windows, exhaust fans and any other gas-burn-
ing appliance to their previous condition of use.
Any improper operation of the common venting sys-
6.
tem should be corrected so the installation conforms
with the National Fuel Code, NFPA-54/ANSI -Z223.1-
latest revision, or section 5 of CSA-B149 for Canadian
standards. When resizing any portion of the common
venting system, the common venting system should be
resized to approach the minimum size as determined
using the appropriate tables in the National Fuel Gas
Code, NFPA-54/ANSI- Z223.1-latest revision, or sec-
tion 5 of CSA-B149 for Canadian standards.
into position with an appliance dolly or 2-wheel hand truck.
The dolly or hand truck should be inserted under the right
hand side of the boiler. It is possible to slide the boiler for
a short distance on a smooth floor or surface.
