15
Changing the comfort temperature permanently
Press the [+] / [–] buttons to set the desired tempera-
ture while in comfort temperature mode.
Keep pressing [F] until the comfort temperature flashes
briefl . The selected comfort temperature has been
changed permanently.
Changing the reduction (duration, day and
temperature) permanently
While pressing [F], press twice on [7] three hours
before the desired onset of the reduction.
“h” (hours) will flash. The set reduction period will flash
afterwards (e. g. 13 = 13 hours).
Press the [+] / [–] buttons to change the reduction
period.
Confirm by pressing [F]
“d” lights up briefl . The set weekday will flash after-
wards.
Use the [+] / [–] buttons to change the day of the week
(Monday = 1, Tuesday = 2, etc.).
Confirm by pressing [F]
The set reduction temperature will flash
Press the [+] / [–] buttons to change the reduction tem-
perature.
Confirm by pressing [F]
The comfort temperature will be lit for the next 3 hours
until the reduction sets in, while the green LED (4) indi-
cates that the reduction has been activated.
Deleting the reduction permanently
Keep pressing [7] until the green LED goes out. The
comfort temperature lights up.
CAbin mode (weekend home)
Every comfort temperature you set while in CAbin
mode will be stored automatically.
Absence settings
Proceed as follows to set the duration of the absence
and the associated reduction temperature:
Press [7] until “d” starts flashing
“01” (01 = 1 day of absence) will flash afterwards
Use the buttons [+] / [–] to set the number of the days
of absence (1 - max. 40 days).
Confirm by pressing [F]
“10” (°C) will flash
Press the [+] / [–] buttons to set the reduction tempera-
ture.
Confirm by pressing [F]
The set reduction temperature lights up, while the
green LEDs (1+4) will flash
The comfort temperature will flash to indicate that the
reduction period is complete.
If no button is pressed, another reduction period will
begin automatically after 48 hours.
Ending the reduction period prematurely
To end the reduction period prematurely, keep press-
ing the [7] button until the comfort temperature is dis-
played.
Functions available for all mode settings
Child-proofin
Activate:
Press the buttons [5] and [7] at the same time until “– –”
appears on the display.
Deactivate:
Press the buttons [5] and [7] at the same time until the
indicator on the display starts flashing
Calibration
If the room temperature deviates from the temperature
shown on the display, you can use the thermostat to
adjust the temperature.
Before doing so, ensure that the heater evenly and
constantly keeps the current temperature setting for
an extended period of time. In order to ensure that the
temperature in the room stays as constant as possible,
keep all windows and doors closed during this period.
While pressing [F], press once on [–].
°C flashes 3 times. The set temperature will flash af-
terwards.
Keep pressing [+] / [–] until the temperature indicated
on the display corresponds to the actual temperatures
measured in the room.
Keep pressing [F] until the set temperature flashes
briefl .
The heater will now be regulated to the temperature
value you set. This procedure can be repeated if the
display is still not indicating the correct temperature.
Restoring factory settings
Turn the heater off.
While pressing the [F], turn on the heater and hold the
[F] button down until rE starts flashing
For more information, see chapter “At start-up and after
a power failure lasting more than 24 hours”.
General warranty terms
Our products are covered by warranty according to the
statutory regulations that apply in the various countries.
If you wish to make a claim under warranty, please con-
tact your dealer.
