9
SOFTWARE APPLICATION RESET
When error conditions occur that block the use of the cash register - even after
powering it off and on again (both by pressing the On/Off key and also removing the
220V power supply cord, as described in step 1 on page 2), you must perform a
software application reset operation to restore normal operating conditions.
To activate this procedure:
1.
Power off the cash register by pressing the
key on the operator panel.
2.
Disconnect the power cord from the electrical socket and wait approximately 20 -
30 seconds.
3.
Reconnect the power cord to the electrical socket.
4.
Power on the cash register by pressing and keeping pressed the
key, then
press and keep pressed the
key.
5.
When the "
RESET
" message appears on the touch screen as shown in the
figure below, release the keys.
NETTUN@7000
int’l
RESET
RECOVERY
6.
Press the
key again.
7.
The touch screen calibration procedure starts automatically
(for more information,
refer to the chapter “Calibrating the Touch Screen” in the User Manual).
8.
Perform touch screen calibration and, at the end, wait until the initialisation
procedure completes and a message is printed on the ticket.
The cash register is now operational and ready for use.