Oliver MODEL 777-NT, Руководство пользователя по эксплуатации и инструкция, Страница: 15 / 44

777-NT Variety Slicer
0777S20039 6-2
Removing the Blade Frames (Continued)
Always start by removing the discharge side blade frame first. Both blade frames should
be removed from the discharge side of the machine. You should remove the discharge
side blade frame completely from the machine before starting on the infeed side blade
frame. However each is removed using similar procedures.
NOTE
NEVER LOOSEN THE NUTS ON THE ECCENTRIC PINS OR ATTEMPT
TO REMOVE THEM TO AID IN REMOVING THE BLADE FRAMES.
Start by pulling the hairpin clip from the eccentric pin, located at the top of each blade
frame, see illustration below, then slide the top link toward the lever side of the slicer.
Make sure that the link is forced all the way over to the cross member.
Next remove the two locking cams, eye bolts, with belleville washers, from the bottom of
the blade frame, they secure the frame to the rocker’s swing shaft. The eye bolts can be
removed by turning them counter clockwise once the cams have been removed. See
the next illustration.