Oliver 4260, Руководство пользователя

Страница: 17 / 30

1
5
Basic Operations
Before m aking any c uts on t he s tock, m ake a f ew
practice cuts by r aising t he i nfeed t able to “ 0" a nd
with the power disconnected. In this manner you will
acquaint yourself with the feel of jointer operations.
SURFACING
T wo handed
push block
Adjust depth of cut. It is better to make cuts of ap-
proximately 1/64 inch. This will enable you to hav e
better control over the material being surfaced. Make
several passes if necessary to obtain proper stock
removal.
Never surface pieces shorter than 12 inches or thin-
ner than 3/8 inch without the use of a special work
holding fixture. Never surface pieces thinner than 3
inches without the use of a push block. On stock 8"
to 12" long use a single two-handed push block (Fig.
18). On stock longer than 12 inches use two push
blocks ( Fig. 19). With narrow stock use the type
push block shown in Fig. 20. When surfacing short
stock over 4 inches wide, use two (2) push blocks to
guide material over cutterhead (Fig. 21).
L-shaped push block
for narrow stock
T wo push
blocks for stock
longer than 12
inches
Fig. 18
Fig. 19
T wo push blocks
with dowels
for short stock
over 4 inches wide
Fig. 20
Fig. 21