Fence Assembly and Adjustment
1. Place the fence on the guides as shown in
Figure 7. Look for the rubber nib on the
underside of the fence as shown and make
sure it lines up with the back support rail.
2. Align the fence with the mitre guage slot as
shown in Figure 7 and check to see if the
fence is parallel to the slot.
3. If the fence is not parallel to the mitre guage
slot, lift the fence off the guides and place it
on the table as shown in Figure 8. Turn the
appropriate screw, A to compensate for the
difference. Place the fence back on the
guides and check again for alignment to the
mitre guage. If it is still mis-aligned, repeat
the procedure.
Adjusting the Scale Reader
1. Raise the blade to it’s maximum height.
2.
Place the fence
on the guides on the right side of blade and
then slide the fence toward the blade.
Continue until the fence just touches the
saw teeth. Do not push too hard or the
blade will deflect.
3.
Looking at the
right side scale reader, the red pointer
should match up with the zero mark. If not,
loosen the two screws, B, Figure 9 and slide
the viewer to align the mark with zero.
Tighten the screws.
4.
Move the fence
to the left side of the blade and repeat the
procedure for the left side viewer.
Figure 7
Figure 8
Figure 9
9
