Oliver 0008, Руководство пользователя, Страница: 11 / 29

10
Fence Adjustments: Tilt
Warning: Do not connect the plug to power
source
Fence adjustments are made with the lock
knob (D) shown in Fig. 19
To slide the fence forward or back on the table,
loosen lock knob (D), slide the fence to the
desired position and tighten lock knob (D) to
secure fence.
To tilt the fence forward:
1. Loosen locking handle (E), Fig. 19
2. Place a machinist protractor or triangle on
the table and against the fence. Adjust the
fence to the desired angle and tighten
locking handle (E) to secure the fence.
To tilt the fence back:
1. Loosen locking handle (E), Fig. 19
2. Flip back the stop block (F).
3. Adjust the fence to the desired angle and
tighten locking handle (E) to secure fence.
Caution: When the jointing operation is finished
with the fence tilted back, do not forget to flip the
pivot stop block back to its original position.
Fig. 31
Fig. 19
NOTE: The lock knob (D, Fig. 20) can be
adjusted to a more convenient position
by loosening the nuts on its opposite
end, turning the handle to the proper
position, and retightening the nuts.
Fence Stop Adjustments
Periodically check the 90° and 45° backward
(135°) tilt accuracy of the fence with an angle
measuring device, such as an adjustable
square or machinist’s protractor.
0º Fence Adjustment
Referring to Fig. 20:
The 90º stop is controlled by the stop bolt (A)
and the stop plate (B).
1. Set the infeed table to approximately the
same height as the outfeed table.
2. Move the fence by releasing lock knob (D)
and pushing the fence assembly until it
overlaps the tables.
3. Tighten lock knob (D).
4. Adjust the fence to a 90º angle by releasing
lock handle (C).
Note: The stop bolt (A) should be resting
against the stop plate (B).
5. Place an angle measuring device (G)
Fig.21 on the table closed to fence surface
and pulling up the fence handle (F) to
confirm a 90º setting then tightening the lock
handle (C).
6. Loosen the hex nut (E) until the stop bolt (A)
touch stop block (B) surface.
7. Tighten the hex nut (E) to retain the setting.
8. Double check to the fence is setting square
with table.
Fig. 20
Fig. 21
E
D
F
G
C
D
F
B
A
E