Olimpia splendid Unico Air R410A, Инструкция по эксплуатации и техническому обслуживанию

Страница: 62 / 489

EN - 14
ENGLISH
The air conditioner must be installed on a wall that communicates
with the outside
After determining the best place for installation as described above,
check for the absence of other structures or systems (beams, piers,
pipes, wires, etc.) at the points where the holes are to be drilled,
which would prevent drilling the holes required to install the unit.
Check again to make sure there are no obstacles to air circulation
through the holes to be drilled due to plants and their leaves, slats
or panelling, blinds, gratings or grids too dense, etc.).
2.4 - UNIT ASSEMBLY
The maximum length allowed for the pipes is 1 m, the pipes must
be internally smooth and no bends can be made.
It is necessary to use the grilles provided, or grilles which keep
the same features.
2.4.1 - Drilling the wall
To operate, the unit requires two holes to be drilled in the wall, positioned as indicated
on the drilling template; the holes must be 162 mm in diameter.
• It is possible to install the unit UNICO AIR ON/OFF instead of a unit UNICO AIR
or UNICO AIR R32 without modifying the already existing holes, exception made
for the small condensation drain hole.
In this case, in order not to penalize performances, remove the insulating material
possibly present in the air expulsion hole. The anchoring brackets need new
drilling too.
• Drill the wall using the proper tools to facilitate your job and prevent excess
damage or disturbance to your client.
The best tools for drilling large holes in walls are special drills called core borers
with very high twisting torque and adjustable rotating speed depending on the
diameter of the hole to be drilled.
• To prevent the creation of large amounts of dust and rubble due to drilling, the
core borer can be fitted with a vacuum system applied by means of suction cups
to the drilling zone.