Olimpia splendid SHERPA MONOBLOC B0812, Руководство по установке

Страница: 5 / 44

Remote Controller
GB - 5
E N G L I S H
Choosing the installation site and installation
b Connection cable
• Adjust length and routing of each wire to reach the proper
terminal in the connector block on the mounting base.
(Strip only 6 mm of insulation from each wire to prevent
adjacent wires from shorting together when connected).
• Match and connect equipment wires to proper terminals in the
connector block.
Both power and communication wires must be connected
correctly for proper remote controller operation.
• Push any excess wire into the wall and against mounting base.
• Push the remote controller snap hinge to the base.
• Open the remote controller rear mounting base to expose
mounting holes.
The base can be removed to simplify mounting (snap apart
carefully at hinge to separate mounting base from remainder of
the remote controller).
• Route the remote controller wires through the large hole in the
mounting base.
Level mounting base against wall (for aesthetic value only).
• Mark the wall through the 2 mounting holes.
Drill two 5 mm mounting holes in wall where marked.
• Secure mounting base correctly to wall with 2 screws and
anchors provided, (additional anchoring holes available for
more secure mounting if needed) making sure all wires extend
through hole in mounting base.
Wiring remote controller to the 30AW unit
WARNING:
$GHQTGEQPPGEVKPICP[YKTKPIVQVJGTGOQVGEQPVTQNNGTVWTP
QHHCNNRQYGTVQVJGWPKVVJCVYKNNUWRRN[RQYGTVQVJGTGOQVG
controller.
'NGEVTKECNUJQEMECPECWUGRGTUQPCNKPLWT[QTFGCVJ
The remote controller is connected to the unit using the
HQNNQYKPIKPUVTWEVKQPU4GHGTGPEGYKTKPIFKCITCOUYJGP
making these connections.
2QYGTECDNGCPFEQOOWPKECVKQPEQPPGEVKQPUHTQOVJG
remote controller to the unit 6-conductor cable.
Electrical connections
b
c To 30AW unit
d Rigid PVC conduit, inside ø 30 mm min.
e Plaster approx. 30 mm
f Remote controller
g Connector block
f
e
d
c
g
Wiring materials required
UWRRNKGFD[KPUVCNNGT
ŖUOCNNUETGYFTKXGT
• 6 x 0,5 mm
2
multiple cables. The cable should be
UETGGPGFQHVJG(41*4QT$'.6'0V[RG6JG
UETGGPKPIUJQWNFDGITQWPFGFQPN[QPVJGGNGEVTKEWPKV
panel board.