FUNCTION DETAILS
• DEHUMIDIFICATION indicated by the "drop" symbol light on the control panel.
Compressor and fan are switched on if the minimum OFF time (Cf) has elapsed and if the relative humidity
value is higher than the set point + 3; compressor and fan remain ON as long as the relative humidity value
is above the set point – 3; when below the set point – 3, compressor and fan switch off (the fan switch-off is
delayed by 30 seconds with respect to the compressor) and remain off for a minimum time equal to Cf
(measured as from switch-off of the compressor), at the end of which compressor and fan are switched back
on again if the relative humidity value is greater than the set point +3.
Compressor and fan switch off only in the following cases:
cut in of the tank full switch,
operation in defrosting mode,
alarms (the switching off of fan always delays for 30 seconds compared with compressor.
• DRYING MODE
Compressor and fan are switched on if the minimum OFF time (Cf) has elapsed.
Compressor and fan switch off only in the following cases:
cut in of the tank full switch,
operation in defrosting mode,
alarms (the switching off of fan always delays for 30 seconds compared with compressor.
DEFROSTING MODE
If there is a frost condition (evaporator temperature < Ft and compressor ON) the compressor remains on for
a maximum time equal to Co minutes, at the expiry of which air defrosting takes place (fan on and
compressor off) which terminates when the pre-set temperature is reached (evaporator temperature > St),
compatibly with the minimum compressor OFF duration of 5 minutes.
If the formation of frost is detected and the compressor is stopped due to reaching of the set point before the
expiry of Co the fan remains on until the end of defrosting temperature is reached.
OPERATION WITH CONTINUOUS DISCHARGE
To operate the dehumidifier with continuous discharge, carry out the following operations:
• Take the tank out of the appliance.
• Connect the rubber pipe provided in the outfit to the condensate collection tank (at the top of the tank
compartment).
• Secure the pipe with the metal clamp provided.
• Simultaneously press the increment (key 2) and decrement (key 3) for three seconds, with the machine in
function
The activation of this function is indicated by the flashing "tank" symbol (6).
The continuous discharge function is cancelled if the empty tank is refitted.
