Olimpia splendid AQUARIA SLIM 14 P, Инструкция по установке, использованию и техническому обслуживанию

Страница: 49 / 148

AQUARIA SLIM
ENGLISH
EN - 18
29 Display
Has various functions:
• When the appliance is electrically powered or it is running, the display shows the percentage
of humidity in the room.
• During the percentage of humidity setting (“UP” and “DOWN” keys), it shows the percentage
of humidity you desire to set (if no key is pressed within 5 seconds, the display returns to show
the percentage of humidity in the room).
• When programming the start and switch off time (“Timer” function), the display shows the set
hours or those remaining before the appliance start or switch off.
• When the level of humidity in the room is below 35%, the display shows the “ LO ” message.
• When the level of humidity in the room is above 95%, the display shows the “ HI ” message.
2 - INSTALLATION
2.1 - APPLIANCE TRANSPORT
• Transport and handling of the appliance must be carried out in vertical
position.
If it is transported in a horizontal position, wait at least one hour before
starting it.
• Before moving or transporting the appliance, completely drain condensation
by working as described in paragraph 3.2.a
CAUTION
Transporting the appliance on delicate floors (for instance: wooden floors):
• Completely drain condensation.
• Pay particular attention while moving the appliance since the wheels may
mark the floor.
Although the wheels are made from a rigid material and are swivelling, they
could get damaged by use or excessive dirt.
It is recommended to check that the wheels are clean and that they can
move freely.
2.2 - WARNINGS
A failure to respect what follows may cause damages to the appliance.
a. Install the appliance on flat, stable and on floor level
surfaces.
b. Only connect the appliance to outlets equipped with a
ground system.
c. Make sure that curtains or other objects do not ob-
struct the air suction filters (Fig.5).
d. Make sure to keep a minimum distance of 20/30 cm
between the appliance and the adjacent objects (Fig.1).