OLIMEX© 2015
STM32-P405 user's manual
CHAPTER 2: BOARD DESCRIPTION
In this chapter you will get acquainted with the main parts of the board. Note the names used on the board
differ from the names used to describe them. For the actual names check the STM32-P405 board itself.
2.1 Layout (top view)
The picture below shows the top side of the board and highlights the most important parts.
Notice that all on-board jumpers are SMD type – in order to change the position of the jumpers you
would either need to cut between the pads of the jumper or solder the pads together.
The bottom view of the board is not shown since there is only one important component of the board at
the bottom – the SD/MMC connector. Note that it is a full-sized MMC connector.
Page 7 of 31
