Basic Configuration
On Ethernet Client
Step 1 Choose a client PC and configure it to get a dynamic IP from the Broadband Wireless
Router (AP).
Step 2 Start up your browser and type 192.168.0.1 as the address to enter the web-based manager.
Step 3 Enter the default username and password.
Both values are
admin
(small letters).
Step 4 Go to
Basic
>
WAN Setting
to finish basic configuration. From the drop-down list select
your WAN connection type. Available options include:
Bridge
,
Obtain an IP address
automatically
,
PPPoE
and
Specify an IP address
.
According to the type you selected, different parameters will appear. Refer to
Manual
for
detailed information on these parameters.
After you finish setting all the parameters, click
Apply
.
Note:
You should contact your ISP for the correct connection type and its corresponding
configuration information.
Step 5 Perform the task of
Save
and
Reset
to have new settings take effect. When the connection
is established, the client PCs can access the Internet or remote network through the
Broadband Wireless Router (AP).
On Wireless Client
Step 1 Install the wireless card driver and verify the wireless setting is as below:
1. The default SSID:
IEEE 802.11 LAN
.
2. WEP encryption is
disabled
. Authentication Type is
Open Key
(or
Open System
according to your Wireless LAN Card) .
3. Use
Infrastructure
connection mode.
Step 2 Check that the TCP/IP protocol is installed on your wireless client PC. Configure it to get a
dynamic IP from the Broadband Wireless Router (AP).
Step 3 Enter the default username and password. Both values are
admin
(small letters).
Step 4 Go to
Basic
>
WAN Setting
to finish basic configuration. From the drop-down list select
your WAN connection type. Available options include:
Bridge
,
Obtain an IP address
automatically
,
PPPoE
and
Specify an IP address
.
According to the type you selected, different parameters will appear. Refer to
Manual
for
detailed information on these parameters.
After you finish setting all the parameters, click
Apply
.
Note:
You should contact your ISP for the correct connection type and its corresponding
configuration information.
Step 5 Perform the task of
Save
and
Reset
to have new settings take effect. When the connection
is established, the client PCs can access the Internet or remote network through the
Broadband Wireless Router (AP).
4
