Oldham olct 80, Руководство пользователя

Страница: 70 / 120

5
– Wireless Version
64
Switch No. 8 7 6 5 4 3 2 1
Position OFF OFF OFF OFF OFF OFF OFF
ON
Figure 48: micro switch configuration on the OLCT 80.
■
Position the microswitches as shown below (Figure 49, A) after opening the
cover of the master receiver :
Switch No. 1 2 3 4 5 6 7 8
Position ON ON
OFF OFF OFF OFF OFF OFF
Figure 49: micro switch configuration on the master receiver.
Configuring the addresses
Configuring addresses on OLCT 80s
Each sensor (main sensor, ANA1 , ANA2 ) will have its own address for
communication with the MX43 central controller according to the configuration
of the controller (refer to the document entitled MX43 Central Digital and Analog
Measurement Unit - User Manual ).
Follow the steps below:
■
Configure the addresses of the OLCT 80 as indicated under Serial
connection configuration on page 39.
■
Calculate the address of the OLCT 80's internal wireless care by adding 50
to the slave number of the main sensor.