![background image](http://html1.mh-extra.com/html/oldham/mx15/mx15_installation-and-operating-instructions-manual_3708671014.webp)
15
-
Indicating the maintenance mode, MAN or AUT:
- AUT:
Detection of detector calibration mode of this function (yellow DEL blinking
on MX15)
- MAN: No detection of detector calibration mode
-
Timing (in minutes and seconds) upon exit of «calibration» menu (relays disabled)
-
Validation of potentially modified parameters in this menu (yes or no):
-
If “NO” validated: the changes are not taken into contact
-
If “YES” validated: the new programming will be saved.
2.5.
Initialisation menu (INI)- Start-up
This menu is used to INITIALISE the microprocessor based on the connected sensor
It is used in the following cases:
- by INDUSTRIAL SCIENTIFIC when new equipment is shipped
- during the first installation
- during a cell or sensor replacement
2.6.
Code (access) menu
This menu changes the access code for various menus (1000 in standard upon shipment of
equipment):
-
display the CODE menu (+ and – key)
-
validate it (enter)
-
display current code
-
indicate the new code using the + and – keys
-
validate this new code (enter)
-
finally confirm it (yes/no/enter)
2.7.
Buzzer menu
Allows or does not allow the use of the buzzer embedded to the MX15 central unit:
-
display the BUZZER menu (+ and – keys)
-
validate it (enter)
-
validate ON (active buzzer) or OFF (buzzer off)
-
finally confirm (yes/no/enter)
2.8.
TEST menu (TST)
Disables the relays embedded to MX15 upon voluntary activation of alarms through injection of a
standard gas on the sensor to test the alarms or to calibrate:
-
display the TST menu (+ and – keys)
-
validate it (enter): yellow DEL is blinking
-
yellow DEL is blinking, the TST message and the
key are displayed, confirming that
the relays are disabled during the test or calibration
Attention: this menu should be used for calibration after a first start-up.
Содержание MX15
Страница 21: ...22...