Oldfield 6736, Руководство пользователя

Страница: 7 / 13

Front Panel: Controls And Features
Manual Channel Selector:
This switch is used to select either Channel One or Channel
Two of the 6736.
(Note: The switch must be in the Channel Two position when operating the amplifier with
the footswitch.)
Channel Indicator Light:
This light is on when the amplifier is operating in Channel Two
mode.
Channel 1 Volume:
Controls the gain of Channel One. Rotating the control clockwise will
make the Channel One volume louder and increase overall gain and harmonics.
Channel One Top Cut:
Rotating the Top Cut control clockwise will “roll off” the high end
of Channel One. This control only affects Channel One.
Channel Two Volume:
Controls the gain of Channel Two. Rotating the control clockwise
will make the Channel Two volume louder and increase overall gain and harmonics.
Treble:
Rotating the control clockwise will increase the high end frequency output by the
amplifier.
Middle:
Rotating the control clockwise will increase the mid frequency output by the
amplifier.
Bass:
Rotating the control clockwise will increase the low end frequency output by the
amplifier.
Master:
Rotating the control clockwise will increase the overall volume of the amplifier.
Edge Switch:
With the switch in the down position the amp produces a smooth and rich
tone. Move the switch to the up position for increased volume and an edgier tone. Make
sure the amplifier is in standby mode before changing switch positions. Failure to do so
will not harm the amp but will cause an audible “pop” through the speakers.
Indicator Light:
On when the mains switch is on.
(Reference the front panel viewing left to right)
Page 7
Oldfield Amplifiers