Setup Instructions
STANDROID
Frame and Hover Graphic
Securing the Leveling the Frame
Assembling and Mounting the Hover Graphic
1. Attach the Eye Nut with Wing Bolt (K)
through the hole in the center of the
top Horizontal Support (C).
2. Attach the Eye Bolt (L) to the base at the
screw hole insert located at the back.
3. Connect the Tension Wire (M) - First, the
the Carabiner to the top Eye Nut (K) and
then the Tension Screw to the Eye Bolt
(L) on the base.
4. Turn the middle of the tension screw until
the wire is tight and the display frame is
level.
1.Connect the tubing segments that are
bungee corded together. Each locking
push pin should snap in place.
2.The “T” shaped pieces slide into the two
holes located closest to the inside of the
frame.
3.Unzip the fabric graphic and slide over the
tubing frame so the graphic faces forward
(convex side).
4.Zip graphic closed around the outside
edge making sure that the “T” tubes
protrude through the holes on the back
(concave side) of the graphic.
5.Slide the angled tube supports onto the
ends of the “T” tubes protruding through
the graphic and tighten with wing nuts.
6.Slide the angled tube supports into the
plastic holes at the top of the frame.
1
1
5
6
4
3
Assembled
Frame Profile
3
