TOTAL POS SOLUTION COMPANY
OKPOS
Manual
Service
ZED POS
1. Configuration of Main Board
2. Configuration of Major I/O Ports
Appendix
1. Stand
2. Cable Cover
3. Rear Cover
4. Main Press
5. Internal System Configuration
6. Storage Replacement
Assembly / Disassembly
1. System On/Off
2. Touch Screen
3. Disk back-up and Recovery
4. Dual monitor (Optional)
5. Magnetic Stripe Reader (Optional)
System Installation
and Usage
1. Preview
2. Features and Specifications
3. Parts Description
System Introduction
If a sharp one like a ballpoint pen is used in calibration, damage to the touch screen may occur. This is not the way to be recommended
CAUTION
After you click the Windows start button, select as follows:
<
Program ▶ PenMount Windows Universal Driver (WHQL) ▶ Utility
▶ PenMount Control Panel
>
Select
‘
PenMount 6000 RS232
’
in device selection tab to configure in
‘
PenMount Control Panel
’
Press
‘
Standard calibration
’
button in the coordinate calibration tab
Follow the on-screen instructions
4
3
2
1
If touch screen is not calibrated correctly, re-calibrate as follows
● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ●
2. Touch Screen
Close the application you are using
Click the start button and then select the
‘
Turn-Off Computer
’
When
‘
Shut Down
’
message appears on the screen, select
‘
Off
’
to shut down the system
3
2
1
System Turn-off