11
How to setup the Chiller
Use the
Water Tubes
to connect the Chiller to the Heating/Cooling Box.:
1.
One of the ends of the
red marked Water Tube
is composed of 10 mm ID black butyl isolated tube
with a manual valve in the middle. Connect it to the color-related connector, the water inlet port, on
the rear panel of the Chiller. The other end has to be connected to the color-related push to fit
connector on the side panel of the Heating/Cooling Box (see Figure 9).
Chiller
Heating /
Cooling Box
Figure 9. red marked Water Tube
–
connection.
Make sure to strongly push the tubes all the way into push to fit connectors to avoid water leakage.
To remove tubing from the connectors, push the rubber ring while pulling the tubing.
If the tubing does not come out easily, do not force it, simply make sure the ring is pushed properly.
2.
One of the ends of the
blue marked Water Tube
is composed of 10 mm ID black butyl isolated tube
with a manual valve in the middle. Connect it to the color-related connector, the water inlet port, on
the rear panel of the Chiller. The other end has to be connected to the color-related push to fit
connector on the side panel of the Heating/Cooling Box (see Figure 10).
Chiller
Heating /
Cooling Box
Figure 10. blue marked Water Tube
–
connection.
