OKM FS Future GeoSeeker Mini, Руководство пользователя

Страница: 34 / 52

34 Conducting a measurement
You have to keep in mind that for a maximum depth penetration of 100 m (328 ft) you will also need 100
m (328 ft) free space to the left and right of your scan point to put your electrodes into the ground. So it
can be possible that you cannot always scan up to 100 m, e.g. if there is no free space for your
electrodes.
Before starting the actual measurement you have to investigate your area to find out what parameters
are useful. While creating a new measurement you have to set up several settings regarding scan points
and maximum depth.
See section 5.1 “New Measurement” on page 22 for setting up a new measurement. As soon as all
parameters have been adjusted and the screen from figure 6.4 appears, you have to put your electrodes
at the correct positions into the ground.
You will now arrange all your equipment according to these instructions. For our example it will be as
follows:
• A … In this example each Power Electrode has to be placed in a distance of 5 m to the left and
right of the control unit. This corresponds to the power cable marker “1”. So you will unroll your
cable until the marker “1” is reached and then you put the electrode into the ground.
OKM GmbH
www.okmmetaldetectors.com
Figure 6.3: Power injection depth depends on electrodes distance
Figure 6.4: Instruction screen for setting up a measurement
A = Marker position of
power electrodes
Continue
B = Marker position of
voltage electrodes