OKM FS Future GeoSeeker Mini, Руководство пользователя

Страница: 24 / 52

24 Operating Modes
Detailed information about the scan points and adjusting the distances you will find in chapter “6
Conducting a measurement” on page 31.
After all electrodes have been adjusted push the button to start measuring the current scan
point. While the scan takes place the screen from figure 5.5 is shown.
The GeoSeeker Mini is now processing several measurements by generating electricity and measuring
the resultant voltage.
DANGER! HIGH VOLTAGE!
While the scanning process is in progress DO NOT touch any of the electrodes.
As soon as the current scan point has been measured the according result will be presented as shown in
figure 5.6. All single measure values will be presented to the operator.
Detailed information about all measure values and its meanings can be found in section 7.1
“Interpretation of scan values” on page 44.
You can also write down these values if you like to keep the results for own calculations or reports.
When you are ready to continue with the next scan point push the button. Now you have to adjust
the electrodes according to the information on your screen again (see figure 5.4 on page 23).
This procedure will repeat until all depths of the current scan point have been measured. Then the
screen from figure 5.7 appears.
OKM GmbH
www.okmmetaldetectors.com
Figure 5.5: Measuring the current scan point
Figure 5.6: Measure values as indicated during a measurement
Measure values
Continue