4
CPU Holder Con'nued:
a) Once both parts #D are secure in place and the ends
are both poinng straight up a 90 degree angle, a+ach
the “U” shaped part #E as shown.
b) Align the two open ends of part #E over the two ends
of both parts #D. The ends of part #E will slip over part
#D.
c) Gently push part #E all the way down.
Power Assembly
a) Idenfy the metal winder part #F and the power strip
part #G.
b) Part #F will slip over the power strip with only the
switch and the outlets accessible with the cord of the
power strip hanging out from the bo+om as shown.
c) To a+ach the enre power assembly to the unit, begin
by locang the two holes on part #F, one on top and
one on bo+om.
d) These two holes will align with the two holes on the
side wall of panel #A as shown in the illustraon.
e) Once the two holes on part #F are aligned with the
holes on the side wall, use the two screws part #1 and
thread them through the hole on the metal winder and
through the side panel.
f)
Once the screws are completely threaded through, use
two nuts part #2 and secure the bolt from the inside of
the cabinet.
Step 3
STEP 4
Congratula'ons!!! Your PRC 450 is
now fully assembled!!
