Copyright © 2009~2011. All Rights Reserved.
6
I-301
http://www.okinausa.com
R201110-V07
(2) Function Selection Dipswitch
FL (Flickerless)
If the camera is used with 50Hz fluorescent lighting,
flicker may appear on the screen. In this case, FL switch should be set to
FL position and switched to OFF position if 60Hz power source is
applied.
AGC (Auto Gain Control)
Set to AGC position, the camera’s sensitivity
is automatically increased when level of ambient light drops. AGC
function automatically controls signal gain in the range of maximum
28dB.
AES (Auto Electronic Shutter)
Set to OFF mode for auto iris control
and AES mode for fixed or manual iris control (The default is OFF
mode).
BLC (Back Light Compensation)
Set to BLC position, it is useful when
the camera is facing an object that has excessive light behind it
(Ex.: Camera installed facing a doorway).
Factory Default Setting
(3) IR Distance/Power Adjustment
Installer may use IR adjustment function according to installation
conditions. It is suggested that the view angle should be checked before
setting up the IR distance. Below is the suggested LED brightness and IR
distance adjustment table:
