OKIN Refined Electric Technology Co.,Ltd
Page 3 of 5
The procedure to set these special positions is below:
Step 1: Adjust the Head and Foot position or Lift position to a desired position by
pressing the button HEAD_ UP or HEAD_DOWN or FOOT_UP or FOOT_DOWNor
LIFT_UP or LIFT_DOWN;
Step 2: Press and hold the
button for 3sec, backlight LED start flashing;
Step 3: Release the
button then click one of
or
or
button before LED stop flashing. Then the Flashing stops immediately to
indicate the corresponding operating has completed successfully.
ALL of the Zero gravity position and the Memory A positionand the Memory B
position can be restored to default sets by pressing and holding the
button for approximate six seconds until the backlight LEDs finally stop
flashingfrom first flashing.
Only Memory A can store Lift position.
J.
FLASHLIGHT
button
：
Click the button, the Flashlight on the remote control will
turn on if it is being off or turn off if it is being on.If the Flashlight is turning on as the
button pressed, it will keep on as long as the button pressed. When the button is released,
the Flashlight will still keep on for several seconds then turn off with the backlight turning
off together.
K.
UNDERLIGHT
button
：
Click the button, the Under-light under the bed will turn on
if it is being off or turn off if it is being on.If the Under-light is turning on as the button
pressed, it will keep on for 5 minutes then turn off automatically if the button isn’t pressed
again.
3
、
Wireless pairing operation
Step1: Push the DIP Switch on the remote control to a certain position
（
different from the
position on the other remote controls paired with the near other control boxes.
）
and put in the
batteries.
