Oki MC770x, Руководство пользователя

Страница: 62 / 78

Replacing Consumables / Maintenance Units
- 62 -
2
1
3
4
5
6
7
Replacing the Belt Unit
Recommendation for Replacing the Belt Unit
When the belt unit nears the end of its lifespan, the message
[Time to Replace Belt] will appear on the control panel to notify
you that it is time to prepare a new belt unit. You can continue
printing until the message [Replace Belt] appears, then printing
will stop.
The belt unit is recommended to be replaced after about
60,000 prints on A4-sized paper (single-sided printing).
However, this page yield is for common printing conditions (3
pages at a time). Printing one page at a time can reduce the
belt life by half.
Memo
• After the message [Time to Replace Belt] appears, you can
continue to print before the message [Replace Belt]
appears.
Note
• Even after the message [Replace Belt] appears, you may
still be able to print by opening and closing the top cover.
However, we recommend replacing the belt unit as soon as
possible.
Replace the belt unit
1
Press the [POWER] button until a "pip"
sound is heard. "Shutdown is in progress."
appears for a while, and then the power is
turned OFF.
Note
• Do not turn off the device abruptly. It can cause
malfunctions.
2
Hold the handle and lift the scanner part.
3
Push the top cover open button to open the
top cover.
4
Remove the old belt unit.
(1) Remove the four image drum cartridges,
and put them on a table or flat surface.
(2) Cover the image drum cartridges with
paper to minimize their exposure to light.
Scanner part
Handle
There is a risk of getting burned.
Do not touch the fuser unit. It can be extremely hot.
Caution
Top cover
Top cover open button
Image drum
cartridge