Oki LE850, Техническое описание

Страница: 19 / 180

- 17 -
5.3 SELECTION OF RIBBON TYPE
Among the Zebra commands, the ^MT command sets ribbon type. If the ^MT command is not sent to
the printer, ribbon type set by this parameter will be valid. If a ribbon error occurs when a direct
thermal paper is used, check the ribbon type setting.
NOTES : 1. Whether the ribbon saving function is enabled or not in the case of thermal transfer printing
or whether the head up function is enabled or not in the case of direct thermal printing,
specified in the Z-MODE, supersedes the ^MT command.
2. Since the LE840D is a direct thermal printer, it always behaves in the same way as
“WITHOUT RIBBON”, regardless of the setting of this parameter.
5.4 SELECTION OF PRINT MODE
Among the Zebra commands, the ^MM command sets print mode. If the ^MM command is not sent to
the printer, print mode set by this parameter will be valid. If the printer does not cut or peel labels,
check the print mode setting.
5.5 SELECTION OF SENSOR TYPE
Among the Zebra commands, the ^MN command sets sensor type. If the ^MN command is not sent to
the printer, paper width set by this parameter will be valid. If a paper jam error occurs, check the
sensor type setting.
NOTE:
Whether to use normal labels or pre-printed labels with the transmissive sensor or whether to
enable the normal detection or manual threshold with the reflective sensor, specified in the Z-
MODE, supersedes the ^MN command.
FEED
RESTART
•
WITH RIBBON
•
WITHOUT RIBBON
FEED
RESTART
•
NO CUT
•
PEEL OFF
•
PEEL OFF A
•
WITH CUT
•
DELAYED CUT
•
RFID (Reserved. Same printer behavior as in NO CUT mode)
FEED
RESTART
•
TRANS
•
TRANS PREPRINT
•
REFLECT MANUAL T
•
NONE
•
REFLECT