Oki C7200, Руководство по обслуживанию

Страница: 388 / 391

Chapter 6 Troubleshooting Procedures
Page: 174
Table 6-1-1 Operator Alarms (2/2)
Message Cause Error Description Solutions
Service Call
125: Error Error detected at
the MT home
position. 1) Is the error message displayed?
2) Does the error repeat? Yes
Yes Turn off/on the printer.
Replace the MT.
Service Call
130: Error Temperature rise
at the LED head
detected. 1) Is the error message displayed?
2) Does the error repeat? Yes
Yes Turn off the printer
leave it for 30 mins. and
then turn it on again.
Replace the LED heat
unit.
Service Call 131:
Error
~ 134 Error No LED heat unit
detected when
turning on the
printer or closing
the cover. 1) Is the error message displayed?
2) Is the LED head mounted properly?
3) Does the error repeat? Yes
Yes
Yes Verify the installation of
the LED head. Turn
off/on the printer.
Replace the LED head
Assy.
Service Call 140:
Error
~ 142: Error Error detected
with the D located
at appropriate
position. 1) Is the error message displayed?
2) Does the error repeat? Yes
Yes Turn off/on the printer.
Replace the Drum Assy.
Service Call 150:
Error
~ 153: Error Fuse in the ID
unit has not been
blown. Is the ID unit mounted properly? Yes Confirm the cable
connection, or replace
the Engine board.
Service Call
154: Error Fuse in the Belt
unit has not been
blown. Is the Belt unit mounted properly? Yes Confirm the cable
connection, or replace
the Engine board.
Service Call
155: Error Fuse in the Fuser
unit has not been
blown. Is the Fuser unit mounted properly? Yes Confirm the cable
connection, or replace
the Engine board.
Service Call 160:
Error
~ 163: Error Error detected by
Toner sensor. 1) Is the error message displayed?
2) Does the error repeat? Yes
Yes Replace Toner sensor
or Assy (Y71-PWB).
Same as the above.
Service Call 170:
Error
171: Error
174: Error
175: Error Short or open
circuit detected at
the Fuser
Thermistor. (H or
L temperature
error) 1) Is the error message displayed?
2) Does the error repeat? Yes
Yes Turn off/on the printer.
Replace the Thermistor
and turn off the printer.
Leave it for 30 mins.