4
12. Remove the top of the blank unit: you need
this to install the Puncher-Unit. Store the bo-
ttom of the blank in case you ever remove the
hole punch from the finisher.
13. Align the pins at either end of the Puncher-Unit
with the holes in the finisher housing, then
slide the Puncher-Unit into place.
14. Secure the Puncher-Unit in place: use two
of the screws (
1
) you removed earlier, plus
the screw (
2
) supplied with the hole punch
accessory.
15. Open the finisher top cover and snap the top
of the blank into place on the Puncher-Unit.
16. Close the top cover and secure the Puncher
-Unit in place with two screws at either end.
