2
INTRODUCTION
The MX-DS1 is a hand-held desoldering tool which utilizes shop air to create a powerful
Venturi vacuum to clean through-holes quickly and efficiently. Paper solder collection liners
within the hand-piece barrel are easy to maintain and are an improvement upon traditional
glass tubes. Shop air is required for operation.
ACCESSORIES & SPARES
MX-DCF1
DS1 Filter Pack; 15 Chamber Liners, 6 Fume Filters
MX-DCF1L
DS1 Chamber Liners (pack of 40)
MX-MCF1F
DS1 Fume Filters (pack of 20)
MX-DAR1
Air Regulator and Filter with Fittings
AC-TC-P
Desolder tip Cleaner (Pack of 12)
AC-CB1-P
Desolder Chamber Cleaning Brush (Pack of 25)
AC-CB2-P
Desolder Tube Cleaning Brush (Pack of 6)
MX-DVC-1
Venturi Cartridge for Desolder Gun
MX-DSL1
DS1 Chamber Seal
MX-DSL2
DS1 Cartridge Seal
MX-DSB
Desolder Gun Swivel Bushing
MX-DLA
Desolder Gun Latch Adjustment (Pack of 10)
MX-DMK1
DS1 Maintenance Kit
CHOOSING THE CORRECT
GEOMETRY
Select a tip with an inside diameter
larger than the lead diameter. Select a
tip with an outside diameter that is
approximately the same size as the
pad.
A standard STDC cartridge can
desolder a maximum lead length of
0.0170." For fast, safe removal of
devices that are difficult to reach on
densely populated boards, or to remove long pin connectors, try the STDC long reach
cartridges. They are identical to standard STDC tip cartridges, but with a 0.46" long extension
at the tip.
CHOOSING THE CORRECT TEMPERATURE (SERIES)
Start with a 600 Series cartridge, switching to a
700 Series only where absolutely necessary; for
example, when working with ground planes or
multi-layer boards. For long reach tips, start with
a 700 Series cartridge.
For extremely heavy loads tied to ground planes,
or very thick multi-layer boards, 800 Series
cartridges may be necessary.
Inside Outside
Part Number
Dia.
Dia.
600
700
800
LONG
long reach
(A)
(B)
Series
Series
SERIES
Reach*
800 series
0.025"
0.055"
STDC-002
STDC-102
STDC-802
N/A
N/A
0.030"
0.066"
STDC-003
STDC-103
STDC-803
STDC-703L
STDC-803L
0.040"
0.070"
STDC-004
STDC-104
STDC-804
STDC-704L
STDC-804L
0.050"
0.080"
STDC-005
STDC-105
STDC-805
STDC-705L
STDC-805L
0.060"
0.090"
STDC-006
STDC-106
STDC-806
N/A
N/A
0.095"
0.125"
STDC-007
STDC-107
STDC-807
N/A
N/A
** When using long reach cartridges, 600 series heat delivery is insufficient for fast, safe device
removal. Therefore, long reach desolder tips are only available in 700 and 800 Series.
Correct
Too Small
Too Large
