www.ojedausa.com | 5
The location of the cooler must be kept away from sources of heat and humidity including direct sun-
light, toasters, ovens, coffee warmers, other appliances condenser air discharge, infrared heaters, or
other heat generating appliances.
Overloading the freezer forces the compressor to run longer. Do not exceed the load limit according
to labels fixed on the inner cabinet (which corresponds to the baskets height).
Product to be loaded should be at -4° F (-20° C) since the equipment is intended for maintaining a
cool product at 0° F (-18° C) at load level rather than freezing a warm product
Keep the lids closed to avoid warm air and moisture getting into the freezer.
The NBH series of units are not intended to be a pull down freezer and as such the product must be
loaded at their intended merchandising temperature.
Before loading products, allow the equipment to operate empty for at least four hours.
ENERGY SAVING IDEAS
PRODUCT LOADING
The power cord of this appliance is equipped with a 3-prong (grounding) plug which mates with a
standard 3-prong (grounding) wall outlet to minimize the possibility of electric shock hazard from this
appliance. The use of extension cords is not permitted and will void the warranty.
Before connecting your equipment, check that the electrical data on the data plate match your elec-
trical output. If voltage varies by 10 percent or more, freezer performance may be affected. Operating
the freezer with insufficient power can damage the compressor. Such damage is not covered under
the warranty. If you suspect voltage is high or low, consult your power company for testing.
To prevent the freezer from being turned off accidentally, do not plug unit into an outlet controlled by
a wall switch or pull cord.
Do not pinch, knot, or bend the power cord in any manner.
IMPORTANT NOTICE: PLUG THE EQUIPMENT INDEPENDENTLY TO A LOAD CENTER WITH AN
APPROPRIATE CIRCUIT BREAKER ACCORDING TO THE NAMEPLATE AMPS.
ELECTRICAL REQUIREMENTS