p. 6
４．
Abnormal stop
４
.
１
Irregular extracting stop
When screws are taken out before the set number of screws are fed, the machine decides
it's an irregular extracting, and it stops feeding.
On Remote Mode, after detecting an irregular extraction, OUT8 changes from HI output
to Low output.
Restarting operations are different for each mode.
・
On Local Mode
When detecting the extraction site closed, the operation restarts and
the counter is reset to zero.
・
On Remote Mode
After an irregular stop, if the extracting drawer is opened and closed,
the machine will restart.
Details are found on Timing Chart 2 (page 10).
４
.
２
Overload stop
When the screw feeder indicates an Overload stop signal, the Overload LED lights up.
On Remote Mode, after the overload signal is detected, the terminal OUT7 changes from
HI to Low.
Details are found on Timing Chart 3 (page 11).
To restart, switch ON the power.
Shut the power OFF to resolve any problems such as reducing the amount of screws in
the hopper.
Then turn the power ON again to restart.
