Öhlins Asia Co. Ltd
700/937 Moo5, Tambol Nongkhaga,
Amphur Phantong, Chonburi Province
20160 Thailand
© Öhlins Asia Co. Ltd. All rights
reserved. Any reprinting or
unauthorized use without the written
permission of Öhlins Racing AB
is prohibited.
Öhlins products are subject to
continuous improvement and
development, therefore, although
these instructions include the most
up-to-date information available at
the time of printing, minor updates
may occur.
To find the latest information
contact an Öhlins distributor.
Please contact Öhlins if you have
any questions regarding the
contents in this document.
SETUP DATA
Spring
preload
adjuster
ADJUSTME TS
Part no. MI_DU 907_EN 0
Issued 2019-09-27
Rebound
Adjuster
Length
Adjuster
Compression
Adjuster
arninge!
⚠
Before riding, always make sure that the basic
settings made by Öhlins are according to
recommended
Set-up Data. Read about adjustments and setting
up in the Öhlins Owner’s Manual before you
make any adjustments. Contact an Öhlins dealer
if you have any questions about setting up.
Max. Position
Min. Position
arninge!
⚠
The adjustable end eye/bracket must not be
threaded out more than that the groove is fully
visible beneath the lock nut. This is maximum
length. After adjusting, make sure that the lock
nut is tightened (30Nm).
Recommended set-up
Spring Preload........................
17 mm.
Compression adjuster.............
2 Clicks
Rebound adjuster ..................
18 Clicks
Shock absorber data
Length .............................
378
+8
/
-2
mm.
Stroke ..............................
94 mm.
Spring
Installed spring
Part No ................... 60480-12
Free spring length...
230 mm
Spring rate..............
Prog 16-26 N/mm
Preload adj.range.... 0-27 mm
