background image

1

2

How to install

Adjustments

Warning!

It is advisable to have an Öhlins dealer install the 
shock absorber.

When installing, consult your Vehicle Service 
Manual.

1

Put the motorcycle on a workstand so that 
the rear wheel barely touches the ground.

Warning!

Make sure the vehicle is securely supported so 
that it will not tip.

2

Loosen the upper and lower attachments of 
the original shock absorber.

Note!

Before installing the Öhlins shock absorber clean 
the vehicle thoroughly.

3

Install the Öhlins shock absorber in the same 
way as the original unit.

Note!

Normally the shock absorber is installed with the 
cylinder head upwards. Make sure that there is 
enough clearance to other details both in loaded 
and unloaded position.

4

Lower the motorcycle so that the shock 
absorber is slightly compressed, before 
tightening the screws.

Caution!

Make sure that all screws are tightened to the 
correct torque and that nothing fouls or restricts 
movement of the shock absorber when the 
suspension is fully compressed or extended.

Warning!

Before riding, always make sure that the 
basic settings made by Öhlins are according 
to recommended Set-up Data. Read about 
adjustments and setting up in the Öhlins 
Owner’s Manual before you make any 
adjustments. Contact an Öhlins dealer if you 
have any questions about setting up the shock 
absorber.

Recommended set-up

Spring Preload 

 

25 mm 

Spring, free length 

 

220 mm

Shock Absorber Length 

330 mm

Stroke 

 

84

Read about Free Sag and Ride height in 

the Öhlins Owner’s Manual.

Set-up Data

Spring Preload 
Adjuster

3

washers

sleeve

Отзывы: