For example, we are looking for the interruption of a line in the earth. The mode is the
single-ended application.
After the transmitter was taken as described above in operation, switch the receiver
with a short press on the power button. To check if the power is on the lowest red led
(it is the left Led in the picture) lights. As you approach the recipient of the affected
line, depending on the signal strength, the Leds shine red, yellow or green. The more
Led's light, the higher the received signal. In addition, they hear the beep, the speed
of which increases with increasing signal. Keep the receiver (as in the picture) and
rotate it through 90 °, you quickly identify the direction of the installed cable. Now you
can walk along the line until you cannot detect a received signal anymore. Now you
move slowly backwards until the signal can be seen again. You have the interruption
and want to locate the exact position. For this purpose press the button near field and
put the receiver close to the ground, check with slow movements where you can
receive the signal and from which point you cannot see the signal anymore. Now you
have found the exact interruption in the affected line.
The receiver will turn off after
one hour, but can be turned
on again. If the receiver is
not turned on, the battery
has under voltage and the
security level to prevent deep
discharge is working. The
transmitter must be charged
using the AC adapter. The
charging socket is
splashproof under the yellow
border..
