ST400 & ST400M Portable Meter
EN-17
and resistivity.
Note: to ensure accurate measurement of ST400M, please use a conductivity electrode with a
built-in temperature probe.
3.7
Two-parameter measurement*
This section only applies to ST400M.
ST400M can display pH (or mV) and conductivity (or Salinity, TDS, Resitivity) at the same time.
Press
to switch between pH, conductivity and two-parameter mode.
3.8
Using the memory
3.8.1 Storing a reading
The
ST400M
can store up to 1000 results (pH and conductivity add together).
Press button-
when the measurement reaches its final reading,
M001
indicates that
one result has been stored.
If you press button-
when
M1000
is displayed,
FUL
displays to indicate the memory is full.
To store further data you will have to clear the memory.
3.8.2 Review from memory
Press and hold the button
to enter setup mode, press button-▲ or button-▼ to select "data
management", you can review all or partial data according to instruction.
3.8.3 Clearing the memory
Press and hold the button
to enter setup mode, press button-▲ or button-▼ to select "data
management", you can delete all or partial data according to instruction.
3.8.4 Export the stored data
The meter can connect the computer through the Micro-USB cable and export the storage result
directly. Do not measure when connecting to the computer!
The steps are as follows:
Connection meter and computer
Confirm that the software (Scalemate) has been installed on the computer.
Go to Ohaus website, Support
→
Software and Drivers.
Содержание ST400
Страница 2: ......
