OHAUS SCOUT, Инструкция по эксплуатации

Страница: 3 / 48

USB Host Interface EN-1
INTRODUCTION
This Interface Kit is for use with Ohaus Scout STX, SPX, SKX and SJX series
products. The USB Host Interface will help you to export or import the menu
settings and application mode setting parameters. You can also save the weighing
results to the USB flash drive.
INTERFACE INSTALLATION
Install the Interface module on the mini DIN port (round connector) located at the
rear side of the balance as shown. During this process, please make sure the
balance is powered off.
Notes:
 Please make sure the small triangle mark (▲) on the round connector is at
the bottom and then plug in.
 The appearance of your model may be different.
SETUP & OPERATION
Upon installation of the interface, the balance will recognize the USB Host Interface
and add relevant items to the menu. The USB flash drive must be installed into the
USB Host interface before using the Export/Import operations. See following tables.
For SPX, SKX and SJX Balances:
Upon installation, the balance will show [
U.S.B.H.S.t
] during the power sequence.
PRINT
Reset:
no
, yes
Stable:
off
, on
A.Print:
off
On.stable (->
Load
, Load.Zero)
interval (->
1
….3600)
accept
continuous
Content: Result (-> off,
on
)
Gross (->
off
, on)
Net (->
off
, on)
Tare (->
off
, on)
Header (->
off
, on)
Footer (->
off
, on)
Mode (->
off
, on)
Unit (-> off,
on
)
Info (->
off
, on)
Layout: Format (->Single,
Multi
)
Feed (->
Line
, 4 Lines, Form)
End Print: Exit menu
USB.HST (USB Host)
E.Menu:
no
, yes
E.APP:
no
, yes
I.Menu:
no
, yes
I.APP:
no
, yes
End USB: Exit menu
Note:
Items with bold font are default settings.
Mini DIN port
(Round connector)