Ranger
™
7000
Quick Start Guide
Ranger 7000
Quick Start Guide
ii
Ohaus Corporation www.ohaus.com
Installing Components
Refer to the illustrations and instructions below to identify and assemble your Ranger 7000 scale with its
components. All components must be assembled before using the scale.
Terminal Setup
When the Ranger 7000 is delivered, the Terminal is already attached (docked) to the Base. No additional
setup is necessary. Refer to the illustrations and instructions below to identify and assemble your Ranger
7000 Scale.
Note:
The Terminal is identical for all Ranger 7000 Scale models.
Installing the Wind Ring, Weighing Platform
1. Place the Wind Ring in position
(R71MHD3, R71MHD6).
2. Place the platform onto the
spider.
Selecting the Location
Avoid excessive vibrations, heat sources, air current, or rapid temperature changes. Allow sufficient
space.
Note:
Interface cables connect to the terminal. The terminal can be detached and mounted on a wall
or positioned on a table separate from the scale.
Connecting Power and Turning ON the Scale
The Ranger 7000 comes with an AC power cord. Connect the power cord to a suitable grounded electrical
outlet and press the ON button on the side of the base (see figure below).
Attention:
Allow equipment to warm up for 60 minutes for optimal weighing performance.
Power ON Button
