Navigator
Balance
Ohaus Corporation www.ohaus.com
iii
Navigator
Balance
Quick Start Guide
OPERATION
Weighing
First press
Zero
to Power on. Then long-press
Function/
Mode until
wJeIGH
appears
.
5
5
Display shows:
To use a container and
Tare
, see below.
Place sample on platform (example 50g):
Taring
a Container’s Weight
Taring zeros the container weight. With balance on, place an empty container on the platform.
(Container weight)
1
(Container weight tared)
(Place material in container)
(Material and container removed)
(50g sample)
To remove tare, press:
ADDITIONAL OPERATIONS
Use the Mode Menu to activate:
(See back page for details of menu navigation.)
Parts Counting
,
Percent Weighing
,
Display Hold
,
Accumulation
, or
Checkweigh
.
Parts Counting
counts large numbers of items based on the weight of a reference count.
Set an
Average Piece Weight
(APW) or use a previously stored
APW
.
Balance calls for a stored sample size [
Put 10
]
,
which can be changed to 5, 20, 50 or 100.
Place indicated pieces on pan, press
Yes
. Display shows count. (Press
Function
to see APW.)
Percent Weighing
measures weight of a sample as percentage of a reference weight.
Set a
Reference Weight
or use a previously stored one. (Press
Function
to see current Ref Weight.)
After establishing Ref Weight, place sample on pan. Display shows percentage of Ref Weight.
To clear stored Ref Weight, press
Yes
when [
CLr.rEF
] is displayed.
Display-Hold
mode captures and stores the highest stable weight value. With
Hold
activated, place
sample on pan. When balance detects highest stable weigh
t, “Hold” indicator blinks and displayed weight
will not change. Press
Function
to release the held weight value.
Accumulation
stores the total of a series of weight measurements. Add first item, its weight is displayed.
Press
Function
to store weight. [
ACCUmM
] flashes; display shows total weight. Remove first item, add next
item. Balance displays weight. Press
Function
to store. [
ACCUmM
] flashes; display shows new total weight.
Repeat for all items to be added. To clear total, press and hold
Mode
until [
ACCUM
] appears. Press
Yes
when [
CLr.Acc
] appears.
Checkweigh
sets low and high weight limits for portion control. (Press
Function
to view low and high
reference weight limits.)
To set
new limits, press
Yes
when [
CLr.rEF
] appears (after selecting [
CHECK
].)
Balance displays [
SEt. Lo
]
.
Press
Yes
to view “Low” value; repeat
No
until desired number appears, then
Yes
. Repeat for all numbers, and same procedure for [
SEt. Hi
]. When limits are set or accepted, place
sample on Pan.
Accept
indicator shows weight is within acceptable range. To clear stored reference
values press and hold
Mode
until [
CHECK
] appears. When [
CLr.ref
] appears, press
Yes
.
