OHAUS MB27, Инструкция по эксплуатации

Страница: 10 / 64

EN-8 MB27
Troubleshooting
Symptom / Display Possible Cause Remedy
Cannot turn on No power to analyzer Verify connections, fuse and voltage
Weight value blinking Sample weight less than 0.5g Increase sample size
“Tare” shown Pan weight needs set to zero Press Tare
“Close Cover” shown Cover needs to be closed before starting test Close cover
Poor accuracy Improper calibration
Unstable environment Perform calibration
Move the analyzer to suitable location
Cannot calibrate Unstable environment
Incorrect calibration masses Move the analyzer to suitable location
Use correct calibration masses
Err 7.0 Time out
Err 8.1 Pan support has load during power on Remove weight from pan support
Err 8.2 Pan support was removed prior to power on Install pan support
Err 8.3 Weight on pan support exceeds capacity Remove weight from the pan support
Err 8.4 Pan support was removed during weighing Re-install pan support
Err 8.5 Cannot perform temperature calibration Cool down the analyzer
Err 8.6 Current temperature is higher than setting Cool down the analyzer
Err 9.5 Factory calibration data corrupted Contact an Ohaus-authorized dealer
Err 10.3 Temperature sensor out of range – high Contact an Ohaus-authorized dealer
Err 10.4 Temperature sensor out of range – low Contact an Ohaus-authorized dealer
Err 10.5 Temperature sensor defective Contact an Ohaus-authorized dealer
Err 10.6 Temperature sensor defective Contact an Ohaus-authorized dealer
Err 10.7 Temperature out of control Contact an Ohaus-authorized dealer
Err 11.0 AC power is unstable Use a power line conditioner
Err 53 EEPROM checksum error Contact an Ohaus-authorized dealer
Err 54 Loading of calibration parameters failed Contact an Ohaus-authorized dealer
Service Information
If the troubleshooting section does not resolve or describe your problem, contact your authorized OHAUS service agent.
Please visit our web site: www.ohaus.com to locate the OHAUS office nearest you.
Accessories
Description Part No.
Anti Theft Device 80850043
Temp Calibration Kit 11113857
In Use Cover 80252475
Sample Pan Handler 80252476
Reusable Wire Cage 80252477
Reusable Sample Pan 7mm, 3pcs 80252478
Reusable Sample Pan 14mm, 3pcs 80252479
Aluminum Sample Pans, 80pcs 80850086
Pads, Glass Fiber, 200pcs 80850087
Reusable Sample Pan, 3pcs 80850088
Description Part No.
Printer Impact, SF40A 30045641
Printer Impact, SF40A, AM 30064203
Printer Impact, SF40A, EU 30064202
Cable, RS9 M/F,1.5m 12122603
STP103 Thermal Printer, US 80251992
STP103 Thermal Printer, EU 80251993
STP103 Thermal Printer, UK 80251994
Cable, STP103 80252581